Home » Oxford » TecArc / Oxford Drive Roller | Knurled 1.6 & 2.4mm

TecArc / Oxford Drive Roller | Knurled 1.6 & 2.4mm

£13.50 ex VAT

Further Reductions Available On Request 01276 505012

  • Knurled Roller
  • 1.6 & 2.4mm
  • Fits TecArc and Oxford
SKU: FECK1624 Categories: , , Tags: ,

Description

1.6 & 2.4MM KNURLED DRIVE ROLLER FOR OXFORD AND TECARC MIG WELDERS

A knurled drive roller for 1.6 or 2.4mm flux cored wires as used on TecArc and Oxford wire feeders.

Supplied as a single.  One side has a knurled groove for 1.6mm wires and the other side has a knurled groove for 2.4mm flux cored wires.

 

Drive roller measures 30mm outer diameter, 22mm inner diameter, 10mm width and has a keyway fitting.

FITS THE FOLLOWING MACHINES:

TecArc ProfMIGs

TecArc T-MIG and TS-MIGs (You will need x2 rollers for the 4 roll wire feed systems on these machines)

TecArc E-MIGs  (You will need x2 rollers for the 4 roll wire feed systems on these machines)

Oxford MIGMakers

Oxford I-MIGs (You will need x2 rollers for the 4 roll wire feed systems on these machines)

Oxford S-MIGs (You will need x2 rollers for the 4 roll wire feed systems on these machines)

Oxford Multi-Arc Compacts

TecFeed Suitcase wire feed units

 

Oxford and TecArc wire feed rollerU GROOVE ROLLERS

A U groove roller drives softer aluminium wires without being deformed, which may occur if using a V groove roller.  When MIG welding Aluminium its also worth changing your MIG torch liner to a teflon type and using an oversized or Aluminium specific contact tip.

 

Additional information

INPUT VOLTAGE

Single Phase, Three Phase

Reviews

There are no reviews yet.

Be the first to review “TecArc / Oxford Drive Roller | Knurled 1.6 & 2.4mm”