Home » Oxford » Oxford Plasma Cutters » P13008 Cutting Tip / Nozzle 45A – P130 Plasma Torch

P13008 Cutting Tip / Nozzle 45A – P130 Plasma Torch

£26.00 ex VAT

Further Reductions Available On Request 01276 505012

  • P130 Torch
  • P13008 (Pack of 10)
  • Up to 45A Cutting Tip


Cutting Tip P13008 (45A) For P130 Plasma Torches

Pack of 10 cutting tips for use with a P130 plasma torch, as supplied with the Oxford CUTMaker 1000, 1300 and TecArc OPTeCUT 95 and 125 plasma cutters.  The P13008 nozzles can be used for plasma drag cutting, up to 45 amps and providing a fine cut.


The nozzle focuses the plasma arc by funneling gas flow. The nozzle or tip orifice should be clean, symmetrical and the correct size to maintain cutting performance. As the tip or nozzle orifice is worn away with normal applications, the arc will get wider and less defined.


WHEN TO REPLACE: Changeover of this consumable should be performed when the orifice becomes damaged, the edges round off and mis-shapen. Failure to change these can result in poor performance and increased cutting kerf.


The P13008 nozzle is for use when drag cutting up to 45A.



Additional information


3. Electrodes (Pack of 5), 4. Gas distributor, 5. Cutting tips 1.1mm (Pack of 10), 11. Retaining cap, 12. Double pointed spacer