Home » Cutting » Gas Welding and Cutting » NM Cutting Torch Large Circle Cutting Attachment

NM Cutting Torch Large Circle Cutting Attachment

£33.50 ex VAT

Further Reductions Available On Request 01276 505012

  • Circle Cutting
  • Fits NM Torches
  • Brass Construction
SKU: GAS2002 Categories: ,

Description

LARGE CIRCLE CUTTING ATTACHMENT FOR NM CUTTING TORCHES

A cutting attachment for use with Oxy Propane or Oxy Acetylene cutting when using an NM (nozzle mix) cutting torch.

Fits onto the nozzle side of the blowpipe, between the head and cutting nozzle  A standoff/roller located next to the head end of the attachment allows easy manoeuvrability of the torch head over the workpiece.

A centre pin at the opposing end of the shaft acts as the central pivot point and sets the radius of the circle to be cut.  This pivot point can be slid along the rail of the attachment arm to increase or decrease the size of the hole being cut.  Markings on the shaft of the attachment show measurements for circle radius.

 

Instructions for use:

A pierce hole is made in the material in which the circle cut is to be made in.

From the pierce hole, a cut can be made to where the circumference of the hole is to be located.  This will be the starting point for the circular cut.

A centre punch is used to establish a pivot point for the centre of the circle.  This is where the of the circle cutting attachment will locate into.

Sliding the pivot point along the length of the rail sets the radius of the cut.

 

NOTE:  Image is for illustrative purposes and product supplied may differ slightly from that shown.

Additional information

Length

5 metre, 10 metre, 20 metre